In this article, we will talk about what to do if the lock is frozen in the car door.
Contents
Every winter, beginner and experienced motorists have to face the same problem - this is freezing of locks. When you need to urgently go somewhere, and the lock does not open, then a panic begins. In fact, this is not as scary as it might seem and there are some good and quick ways to open locks.
How can you open the frozen castles in winter?
If the castle froze in the door of the car, then there are several ways to open it without harm to the car. We will talk about them later.
First, let's figure out how to do it:
- Use boiling water
- Vaporize and other combustible substances
- Use non -freezing liquid or composition for thawing glasses
Boiling water, especially steep, is able to damage the paint by car, especially since it will solve the problem temporarily. Yes, now you can open the lock, but do not forget that in the cold water turns into ice, which will happen after a while. So, opening the car now, be prepared for the fact that after the first trip it will freeze again. The same goes for "non -freezing." As a rule, they have water in the composition.
The effectiveness of gasoline is a controversial issue. However, it may well harm some elements of plastic or rubber. So, again, it is better not to use it as a means for solving the problem.
There are also situations when the castle itself has not freezed, but the lubricant inside it was “strangled”. In this case, you can try to carefully turn the key. If the castle succumbs and you will feel that the key walks better, then everything is fine and you will open it soon. But if not, then the problem will have to be solved differently.
How to defrost the locks by car if you froze: methods
So, if the lock in the doors of the car froze and the key turning does not help. Then use one of the following methods.
Castle check
Make sure of the performance of all other locks of the car, do not stop only on the driver's door. Perhaps you will be able to get into the car, and then the case is already small - it remains to start it and warm it up. Then the castle melts and the problem will go away. If in this way the driver does not work in this way, then try to climb through the trunk. Keep in mind that it is strictly impossible to open the doors immediately, especially with the use of physical strength. This is fraught with the fact that you will be left without a castle at all, and possibly without a seal for doors.
Rotation of the key
This method is also not bad, but it can only be used if the key enters it all the way. If in the process you feel that the pitching becomes stronger, then you are on the right track. Just don't pull the key too much. It is already fragile, but in the cold the situation is aggravated. As a result, you can be left without a castle.
Heat the key
If it is not possible to rock the lock with a cold key - heat it. Try to ensure that the time after heating and inserting into the keyhole is minimal. Perhaps the first time the issue will not work out the first time. Then try again. If you notice that the key turns better, then you go in the right direction. However, you should not warm too much so as not to damage the key.
Use open fire
We will immediately say that this method is recommended to use only if nothing else helps, because it is dangerous to cover the car, as well as your hands, since there is a risk of burns. To do this, take something long and fuel. Bather and bring to the castle as close as possible. By the way, you can well take the turbo lighter. She has a directed fire and will fall into the well immediately.
Heating the larvae of the lock
There are different options. You can use water or hot sand. These are the most popular options. But then salt or sea salt is quite suitable here. Of course, first in a pan or other surface, the coolant must be heated, and then placed in a vessel, so that then heat goes to the lock.
As for the container, you can use plastic bottles, inflatable balls, pieces of fabric or a dense bag. When choosing, keep in mind that, when exposed to temperature, not only the strength of the product is reduced, but also its volume.
Heating elements and devices
First of all, it can be a household or industrial hairdryer. However, there are features. First of all, this requires a socket, and also an extension cord. It is important to consider the power of the hair dryer. If you heat too much, then you can damage the paintwork. Especially if you decide to use a construction hair dryer. Household hair dryers are not so dangerous, but they must also be able to use them safely. The main thing is to remember that it will not help quickly remove ice. This takes time.
Defrosting agent
This method is the most “civilized” of all. At the moment, a huge number of such funds are offered on store shelves. Moreover, depending on the region, the assortment is different. Each product has instructions for use. The principle may vary. However, the use of most of them boils down to the fact that a “nose” or a tube must be brought to the internal castles of the mechanism and influence the chemical composition.
How to open a frozen car hatching hatch: Instructions
When the lock in the car door froze, this is one problem. However, when the gas tank hatch freezes, the problem is already much more serious. Since the hatch itself is located on the surface of the body, when moisture gets at low temperatures, it easily freezes and does not open in a standard way.
In this case, you can do the following:
- Drive the car to a warm room. This is the most effective way, but also the most difficult to execute. If you drive the car into a garage or car service, then just wait a couple of minutes. The door will thaw and open.
- The use of a construction hairdryer. This is also a good option, but as we already said above, the most difficult, because the power source is very difficult to find. If there is an opportunity, then use the hair dryer very carefully, otherwise you can damage the car paint.
- Using car exhaust gases. They are warm enough and with the help of a hose they can even be directed to a hatch. Then he quickly thaws. But keep in mind that the gases are toxic and they need to be directed in such a way that they do not fall into the face.
Can the ignition lock in the car freeze?
Some motorists are faced with the problem when the lock is frozen at the car door, and also the ignition does not work. In this case, it will not freeze from frost. If you have any problems with the ignition, then here, most likely, electronics or there are other problems. However, they do not concern freezing.
How to make the lock in the car door does not freeze: prevention
So that you do not have to think what to do if the lock was frozen at the door of the car, adhere to a few simple recommendations:
- An excellent preventive way to prevent lock freezing is the use of defrosters. They will not only melt the ice inside the mechanism, but also lubricate it. From this he will work better. It is important that the composition includes Teflon, technical oils or silicone. However, do not use it too often. Enough at least once a week.
- Doors can also freeze. So you can open the lock, but the door itself will stick. A special lubricant can prevent this situation. It is also useful for doors, seals will serve much longer.
- All plastic surfaces of the car are recommended to be treated with grease for door loops. Then they will not freeze and also last longer.
By the way, instead of a defroster, it is quite possible to use brake liquid or engine oil. Instead of lubrication, glycerin or children's cream is suitable.
Video: door locks froze. What to do?
